Rev B design values, preliminaryTPS-400, three-quarter view. Design rendering, Rev B design values, preliminary. Not a photograph. IP work on this design is still open.
Pull
400 short tons (800,000 lb; 3,559 kN) at 4,527 psi on a 5,000 psi power unit
Rev B design values, preliminary
Stroke
48 in; two speeds (4 or 2 cylinders)
Rev B design values, preliminary
Clearance
13.25 in (passes a 10-3/4 coupling)
Rev B design values, preliminary
Full specification
Model
TPS-400
Design pull (lb)
800,000
Pull (short tons)
400
Revision
Rev B design values, preliminary
Pull
400 short tons (800,000 lb; 3,559 kN) at 4,527 psi on a 5,000 psi power unit
Parts designed for
Parts designed for 6,000 psi; relief set at 400 short tons
Proof test
500 short tons (1.25 times the design pull), each unit
Stroke
48 in; two speeds (4 or 2 cylinders)
Stroke speed
About 56 in/min; about 112 in/min fast
Clearance
13.25 in (passes a 10-3/4 coupling)
Height, lowered / raised
79 / 127 in (jack only)
Wellhead spool options
13-5/8 3M, 13-5/8 5M, 11 in 3M, 11 in 5M
Spool height
14 in
Base / head width
51 / 48 in
Weight
About 10,800 lb jack; about 1,700 lb spool
Master bowls
10-3/4 in
9-5/8 in
Insert bowls
7-5/8 in
7 in
5-1/2 in
5 in
4-1/2 in
2-7/8 in
2-3/8 in
Slip sizes
10-3/4 in
9-5/8 in
7-5/8 in
7 in
5-1/2 in
5 in
4-1/2 in
2-7/8 in
2-3/8 in
Bowl
insert bowls
Power unit
5,000 psi, about 43 gpm, 150 to 200 hp
Load holding
Pilot-operated check; velocity fuse on each cylinder
Overpressure
Lockable relief set per string; rod-side relief
Controls
Dead-man lever at a remote control stand
Work floor
Not offered on the TPS-400
Cylinder hydro test
7,500 psi, each cylinder
Rev B design values, preliminary
Design values. The jack is not rated or certified until a licensed PE has stamped the design and the unit has passed its proof test. Pull on any string is limited by the operating relief to 80% of pipe body yield (TPS-200: also limited by slip-crush capacity). The wellhead, a cellar bridge or bearing mats must carry the full reaction load.