A casing jack puts its full pull back into whatever it stands on. Rig-up is mostly about making sure that footing, and everything between it and the pipe, is ready for that load.
1. Before the jack arrives
- Confirm the casing OD, weight, grade and connection, and the pull needed. Slips and inserts must be for that OD.
- Check the wellhead flange size and pressure rating against the jack’s spool. If the wellhead can’t carry the reaction load, plan a cellar bridge or bearing mats.
- Check the site: room to set the jack and the power unit, a clear path for laying pipe down, and a safe place for the crew to stand.
- Confirm well control: what barriers are in place, what pressure is behind them, and whether H2S could be present.
2. Set the base
- Clean the wellhead flange and check the ring groove.
- Set the spool (or the cellar bridge) level and make up every bolt to the right torque.
- Lift the jack onto the spool with a rated lifting arrangement. Nobody stands under a suspended load.
3. Slips and bowls
- Fit the bowls for the casing size. Clean the tapers.
- Fit the slips and inserts. Inserts should be sharp and the right size; dull inserts let pipe slip and crush it unevenly.
- Run the slips up and down by hand to check they seat square.
4. Hydraulics
- Connect the power unit hoses and check every fitting.
- Set the relief to the figure planned for this string: no higher than the lesser of the jack’s design pull, 80% of the pipe’s body yield, and the string’s working limit.
- Cycle the jack with no load. Check stroke, speed and the control lever. The lever must return to neutral when released.
5. First pull
- Set the traveling slips on the pipe and take up slack slowly.
- Watch the gauge and the wellhead. Any movement or settling at the base means stop.
- Bring the pull up in steps to the planned figure.
Slip crush
Slips can crush pipe before it reaches its rated pull. Slip-crush capacity for your pipe is set when the jack is engineered for your order; the relief is set to the lower limit.
Every figure here comes from your own pipe records and the calculators on this site. Check them against the well file before you pull.