The free point is the depth above which the pipe is free to move. Below it, the pipe is held by cement, sand, collapsed casing or anything else. You need it before you cut, because a cut below the free point leaves you trying to pull pipe that is still held.
The idea
Steel stretches in proportion to the pull on it. A longer free length stretches more under the same pull. So if you pull on the pipe and measure how far it stretches at the surface, you can work out how long the free part is.
The test, step by step
- Take a first pull a little over the string’s hanging weight, enough to take out slack and straighten the pipe. Mark the pipe at a fixed reference, such as the top of the wellhead.
- Take a second, higher pull. Keep it well under the string’s working limit (see the max pull calculator).
- Mark the pipe again at the same reference.
- Measure the distance between the two marks. That is the stretch, in inches.
- The difference between the two pulls is the pull used, in thousands of pounds.
- Repeat once or twice. Stretch readings should agree within a fraction of an inch. If they don’t, look for drag or a slipping reference.
The arithmetic
Free length (ft) = stretch (in) × free-point constant ÷ pull difference (thousands of lb).
The free-point constant is 2,500 times the pipe’s cross-section area in square inches. Our free point calculator works it out for every row in the casing table, and the formulas page shows where 2,500 comes from.
Example: 7 in, 23 lb/ft casing has a free-point constant of about 16,639. A stretch of 20 in between pulls 40,000 lb apart gives 20 × 16,639 ÷ 40 = about 8,319 ft of free pipe.
Reading the answer
- The stretch test gives the length of pipe that is stretching freely. Friction against the wellbore takes some of the pull, so the true free point is usually a little deeper than the answer, never shallower.
- Cut a joint or two above the answer, not below it.
- In a deviated well, or where the pipe is partly held over a long interval, a free point tool run on wireline gives a better reading. Use the stretch test to plan, and the tool to confirm.
Every figure here comes from your own pipe records and the calculators on this site. Check them against the well file before you pull.